What to do if Delta ASD-A2-4523 Servo Drives show The absolute position is lost?
If your Delta Servo Drives are showing that the absolute position is lost because of battery undervoltage, after change the battery, conduct homing procedure again.
What to do if Delta ASD-A2-4523 Servo Drives show Encoder voltage error or the internal of the encoder is in error?
If your Delta Servo Drives are showing encoder voltage error or the internal of the encoder is in error: * Battery voltage is too high: According to the procedure of Over voltage to check. When corrective actions are done, AL.028 will be cleared automatically. * The internal encoder is in error: If the situation is not improving, please send the drive back to the distributors or contact with Delta.
What to do if Delta ASD-A2-4523 Servo Drives show Adjustment Error?
If your Delta Servo Drives are showing an adjustment error: * The analog input contact is incorrectly set back to zero: Correctly ground the analog input contact. * The detection device is damaged: If the error still occurs after reset, send the drive back to the distributors or contact with Delta.
What to do if index error occurs when accessing CANopen object on Delta ASD-A2-4523?
If the specified Index in the message does not exist, NMT Maser send “Reset node“ command to its slave or reset the fault by sending the control word (0x6040) through CAN communication (the value of CANopen object 0x6040 should be reset).
What to do if sub-index error occurs when accessing CANopen object on Delta Servo Drives?
If the specified Sub-index in the message does not exist, NMT Maser send “Reset node“ command to its slave or reset the fault by sending the control word (0x6040) through CAN communication (the value of CANopen object 0x6040 should be reset).
What to do if data type (size) error occurs when accessing CANopen object on Delta Servo Drives?
If the data length in the message does not match the specified object, NMT Maser send “Reset node“ command to its slave or reset the fault by sending the control word (0x6040) through CAN communication (the value of CANopen object 0x6040 should be reset).
What to do if data range error occurs when accessing CANopen object on Delta ASD-A2-4523 Servo Drives?
If the data in the message has exceeded the data range of the specified object, NMT Maser send “Reset node“ command to its slave or reset the fault by sending the control word (0x6040) through CAN communication (the value of CANopen object 0x6040 should be reset).
How to fix Data Size error occurs when accessing CANopen PDO in Delta Servo Drives?
To fix data size error occurs when accessing CANopen PDO in Delta Servo Drives, when the data length in the message does not match to the specified object, use NMT: Reset node or 0x6040.Fault Reset.
What to do if Delta ASD-A2-4523 Servo Drives show Wrong setting of E-gear ratio?
If your Delta Servo Drives are showing the wrong setting of E-gear ratio because setting of E-gear ratio is wrong when power on the servo drive, modify the range of E-gear ratio and repower on the servo drive.
What causes serial communication time out in Delta Servo Drives?
A serial communication timeout error in Delta Servo Drives can occur due to: * Improper setting of the time-out parameter: Correctly set the value. * The drive hasn’t received the communication command for a long time: Correct wiring.
General| Brand | Delta |
|---|---|
| Model | ASD-A2-4523 Series |
| Category | Servo Drives |
| Language | English |
To Next Page
