Chapter 7 Parameters ASDA-B2
7-36 Revision May, 2018
P1-34 TACC Acceleration Constant of S-Curve
Address: 0144H
0145H
Operation
Interface:
Panel/Software Communication
Related Section:
6.3.3
Default: 200
Control
Mode:
S
Unit: ms
Range: 1 ~ 20000
Data Size: 16-bit
Format: Decimal
Settings: The time that speed command accelerates from 0 to 3000 r/min.
P1-34, P1-35, and P1-36, the acceleration time of speed
command from zero to the rated speed, all can be set individually.
.
NOTE
When the source of speed command is analog, and P1-36 is set
to 0, it will disable S-curve function.
P1-35 TDEC Deceleration Constant of S-Curve
Address: 0146H
0147H
Operation
Interface:
Panel/Software Communication
Related Section:
6.3.3
Default: 200
Control
Mode:
S
Unit: ms
Range: 1 ~ 20000
Data Size: 16-bit
Format: Decimal
Settings: The time that speed command decelerates from 3000 r/min to 0.
P1-34, P1-35, and P1-36, the deceleration time of speed
command from the rated speed to zero, all can be set individually.
NOTE
When the source of speed command is analog, and P1-36 is set
to 0, it will disable S-curve function.
To Next Page
Loading...
