Delta Electronics Servo Press E-Series Installation and Maintenance Instructions
9
3.2.2 AM-ESP-E010-XXXX / AM-ESP-E005-XXXX models
Please use M8x1.25 threads for the punch jig design.
The design of the fixed punch should not be in contact with the entire surface of the front Loadcell.
It is recommended to design a neck structure to avoid full-surface contact with the front Loadcell.
Caution: The top of the spindle punch is installed with the load cell. Do not assemble tools in a way
that could result in deviations or impacts.
To Next Page
Loading...
