Delta E Series - Safety Symbols and Terminology Definitions

Delta Electronics Servo Press E-Series Installation and Maintenance Instructions
6
3.1.2 AM-ESP-E010-XXXX / AM-ESP-E005-XXXX models
The fixed servo press is installed with a flange. The fastening ports are shown in the figure below.
Please use 4 general M12X1.75 hex screws (JIS strength 12.9, length 60) and apply the tightening
torque of 1160 kgf-cm.
Caution: Please note that the equipment has to be closely attached to the locking and fastening
platform while fastening the servo press.
: Locking and fastening site
Suggested digging size