Delta E Series - AM-ESP-E002-XXXX; AM-ESP-E001-XXXX Models

Delta Electronics Servo Press E-Series Installation and Maintenance Instructions
10
3.2.3 AM-ESP-E002-XXXX / AM-ESP-E001-XXXX models
Please use M8x1.25 threads for the punch jig design.
It is recommended to design a neck structure to avoid full-surface contact with the front Loadcell.
Caution: The top of the spindle punch is installed with the load cell. Do not assemble tools in a way
that could result in deviations or impacts.
Neck
Loadcell
Fixed punch