Delta E Series - Table of Contents

Delta Electronics Servo Press E-Series Installation and Maintenance Instructions
1
Contents
1.
Safety Information............................................................... 2
1.1 Safety Information Before Use ........................................................................... 2
1.2 Safety Information During Use ........................................................................... 3
1.3 Safety Information During Maintenance and Under Other Circumstances ......... 3
1.4 Powering System ............................................................................................... 3
2. Comprehensive System Structure .................................... 4
2.1 Model & Electronic Control Panel ...................................................................... 4
3. Installation Setup ................................................................ 5
3.1 Fixed Way .......................................................................................................... 5
3.1.1 AM-ESP-E050-XXXX/AM-ESP-E030-XXXX models ............................. 5
3.1.2 AM-ESP-E010-XXXX / AM-ESP-E005-XXXX models ........................... 6
3.1.3 AM-ESP-E002-XXXX / AM-ESP-E001-XXXX models ........................... 7
3.2 Loading and Unloading Spindle Punch .............................................................. 8
3.2.1 AM-ESP-E050-XXXX / AM-ESP-E030-XXXX models .......................... 8
3.2.2 AM-ESP-E010-XXXX / AM-ESP-E005-XXXX models ........................... 9
3.2.3 AM-ESP-E002-XXXX / AM-ESP-E001-XXXX models ......................... 10
3.2.4 Restrictions of Jig ............................................................................... 11
4. Equipment Care and Maintenance .................................. 12
4.1 Applying Oil to Equipment ................................................................................ 12
4.2 Load Cell Calibration ........................................................................................ 14
5. Wiring Instructions ........................................................... 15
5.1 Circuit Diagram ................................................................................................ 15
5.2 PLC External I/O Contact Details ..................................................................... 16
5.3 Details of Drive Power Distribution ................................................................... 17
5.3.1 0.4 kW~1 kW ........................................................................................ 17
5.3.2 2 kW~7.5 kW ........................................................................................ 18
Delta Electronics Servo Press (External Electric Cylinder)
Installation and Maintenance Instructions