Delta Electronics Servo Press E-Series Installation and Maintenance Instructions
2
1. Safety Information
1.1 Safety Information Before Use
Item Description
Power Supply
Please shut down power before removing the external power lines to
the unit so that the unit is in a disconnected state when the servo press
will be out of service for an extended period of time.
Please follow the main power and voltage requirements.
Do not let the servo press or power lines get exposed to water or oil.
Make sure that the power line is properly plugged and fastened.
Machinery
For long-term use, please periodically check if the screws fixating
the unit are loose and re-fasten loose ones.
While in operation, warning signs may be put up in the surroundings
to prevent against possible danger.
Do not modify or alter the equipment yourself.
Do not work in areas with direct exposure to sunlight.
During transfer, setup, and operations, avoid collisions with the
equipment.
Please check if the screws are fastened for a jig fixture
punch.
Do not use the equipment in areas with dust and water vapor.
To Next Page
Loading...
Need help?
General
