Delta MS300 Series - Page 376

Chapter 12 Descriptions of Parameter SettingsMS300
367
Fault Code
bit 0
bit 1
bit 2
bit 3
bit 4
bit 5
bit 6
current
Volt.
OL
SYS
FBK
EXI
CE
27: Over torque 2 (ot2)
●
28: Under current (uC)
●
31: EEPROM read error (cF2)
●
33: U-phase error (cd1)
●
34: V-phase error (cd2)
●
35: W-phase error (cd3)
●
36: cc (current clamp) hardware error (Hd0)
●
37: oc (over-current) hardware error (Hd1)
●
40: Auto-tuning error (AUE)
●
41: PID loss ACI (AFE)
●
43: PG feedback loss (PGF2)
●
44: PG feedback stall (PGF3)
●
45: PG slip error (PGF4)
●
48: ACI loss (ACE)
●
49: External fault (EF)
●
50: Emergency stop (EF1)
●
51: External base block (bb)
●
52: Password is locked (Pcod)
●
54: Illegal command (CE1)
●
55: Illegal data address (CE2)
●
56: Illegal data value (CE3)
●
57: Data is written to read-only address (CE4)
●
58: Modbus transmission time-out (CE10)
●
61: Y-connection / △-connection switch error
(ydc)
●
62: Deceleration energy backup error (dEb)
●
63: Over slip error (oSL)
●
72: STO Loss (STL1)
●
76: STO (STo)
●
77: STO Loss 2 (STL2)
●
78: STO Loss 3 (STL3)
●
79: U-phase over-current before run (Aoc)
●
80: V-phase over-current before run (boc)
●
81: W-phase over-current before run (coc)
●
82: U-phase output phase loss (oPL1)
●
83: V-phase output phase loss (oPL2)
●
84: W-phase output phase loss (oPL3)
●
87: Low frequency overload protection (oL3)
●
89: Rotor position detection error (roPd)
●