Delta MS300 Series - Page 377

Chapter 12 Descriptions of Parameter SettingsMS300
368
Fault Code
bit 0
bit 1
bit 2
bit 3
bit 4
bit 5
bit 6
current
Volt.
OL
SYS
FBK
EXI
CE
101: CANopen guarding error (CGdE)
●
102: CANopen heartbeat error (CHbE)
●
104: CANopen bus off error (CbFE)
●
105: CANopen index error (CidE)
●
106: CANopen slave station setting error
(CAdE)
●
107: CANopen index setting exceed limit
(CFrE)
●
121: Internal communication error (CP20)
●
123: Internal communication error (CP22)
●
124: Internal communication error (CP30)
●
126: Internal communication error (CP32)
●
127: Internal communication error (CP33)
●
128: Over-torque 3 (ot3)
●
129: Over-torque 4 (ot4)
●
134: Electronics thermal relay 3 protection
(EoL3)
●
135: Electronics thermal relay 4 protection
(EoL4)
●
140: oc hardware error (Hd6)
●
141: GFF occurs before run (b4GFF)
●
142: Auto-tune error 1
(no feedback current error) (AuE1)
●
143: Auto-tune error 2
(motor phase loss error) (AuE2)
●
144: Auto-tune error 3
(no-load current I
0
measuring error) (AuE3)
●
149: Auto-tune error 5
(rotor resistance measuring error) (AuE5)
●

06-29
PTC Detection Selection
Default: 0
Settings
0: Warn and continue operation
1: Fault and ramp to stop
2: Fault and coast to stop
3: No warning
 Sets the operation mode of a drive after detecting PTC.