Amplon RT Series
32
Start-up with Battery (Cold-start)
NOTE:
To prevent the UPS from activating the overload protection mechanism during start-up
process, please turn on the high-power loads first and then low-power loads.
8.2 Turn-off
Make sure all loads connected to the UPS have been completely shut down.
(1) Press and hold the
ON/ OFF
button ( ) for 3 seconds, (2) release it after you hear
one beep, (3) use the
Scrolling UP
or
Down
button ( / ) to select ‘Yes’, and (4) press
the Enter button ( ) to confirm your selection.
Disconnect the UPS from the AC power.
If you connect the external battery pack(s) to the UPS, disconnect the UPS from the external
battery pack(s).
To Next Page
Loading...
