Delta RT Series User Manual

Amplon RT Series
34
Chapter 9 : LCD Display & Settings
NOTE:
1. Please refer to
Chapter 3: Operation Panel
to learn how to operate the operation
panel and understand every icon/ diagram definition.
2. Each of the display diagrams shown in this chapter is for reference only. Actual display
depends on the operation of the UPS.
The following flow chart helps you to understand how to navigate each display screen.
9.1 Initial Setting Screen
When the UPS is powered on for the first time with the AC input, the LCD display will enter the
Initial
Setting Screen
and you can modify the settings of
Language
,
Date & Time
,
Output Setting
,
External Battery Source
and
External Battery Capacity
based on your needs and actual conditions.
The default settings may vary according to different models. Press the
Scrolling Down
button
to continue if there is no need to change. After initial settings, the
Main Screen
will appear and show
the current operation mode.

Delta RT Series Specifications

General

Transfer Time	0 ms
Topology	Online Double Conversion
Output Voltage	220V/230V/240V (selectable)
Input Frequency Range	40Hz to 70Hz
Output Frequency	50 Hz ± 0.1% or 60 Hz ± 0.1%
Waveform	Pure Sine Wave
Battery Type	Sealed Lead-Acid (SLA)
Communication Ports	RS232, USB, Optional SNMP
Phase	Single Phase
Form Factor	Rackmount/Tower
Operating Temperature	0°C to 40°C
Humidity	0% to 95% (non-condensing)
Protection Features	Overload, short circuit, over temperature, battery deep discharge
Storage Temperature	-15 ~ 50 °C (5 ~ 122 °F)