Delta RT Series User Manual

35
The
Initial Setting Screen
will no longer appear after initial configurations. Next time, when the UPS
is powered on, the LCD display will show
DELTA
welcome page for 3 seconds and then directly go to
the
Main Screen
that shows the current operation mode.
9.2 Main Menu
In the
Main Screen
, press the button for 0.1 second to enter the
Main Menu
. You can set up
relevant items here.
NOTE:
Please note that only qualified service personnel can perform setup actions.
For setup procedures, please refer to the following:
In the
Main Menu
, select the item you want to configure and press the
ENTER
button
for 0.1 second. After that, the UPS will enter the setup mode.
Press the
Scrolling Up
or
Down
button ( / ) for 0.1 second to navigate the setting
items.
Press the
ENTER
button for 0.1 second to choose the parameter that you want to
change, and the parameter will flash.
Press the
Scrolling Up
or
Down
button ( / ) for 0.1 second to increase or decrease
the parameter value. If either of the buttons is pressed for over 2 seconds, the LCD will
automatically switch between the selectable values every 0.2 second until either of the buttons
is released or the parameter reaches its highest or lowest value.
Press the
ENTER
button to confirm your parameter setup or press the
ESC
button
to go back to the previous status.

Delta RT Series Specifications

General

Brand	Delta
Model	RT Series
Category	UPS
Language	English