Chapter 10 Digital Keypad|CFP2000 Series
10-2
10-1 Descriptions of Digital Keypad
KPC-CC02
Communication Interface
RJ-45 (socket)、RS-485 interface;
Installation Method
1. Embedded type and can be put flat on the
surface of the control box. The front cover is
water proof.
2. Buy a MKC-KPPK model to do wall
mounting or embedded mounting. Its
protection level is IP66.
3. The maximum RJ45 extension lead is 5 m
(16ft)
4. This keypad can only be used on Delta’s
motor drive CFP2000.
Descriptions of Keypad Functions
Key
Descriptions
Start Operation Key
1. It is only valid when the source of operation command is from the keypad.
2. It can operate the AC motor drive by the function setting and the RUN LED will be ON.
3. It can be pressed again and again at stop process.
Stop Command Key. This key has the highest processing priority in any situation.
1. When it receives STOP command, no matter the AC motor drive is in operation or stop
status, the AC motor drive needs to execute “STOP” command.
2. The RESET key can be used to reset the drive after the fault occurs.
3. The reasons why the error cannot be reset:
a. Because the condition which triggers the fault is not cleared. When the condition is
cleared, the fault can be reset.
b. Because it’s the fault status checking when power-on. When the condition is cleared,
repower again, and the fault can be reset.
Operation Direction Key
1. This key is only control the operation direction NOT for activate the drive. FWD: forward,
REV: reverse.
2. Refer to the LED descriptions for more details.
ENTER Key
Press ENTER and go to the next level. If it is the last level then press ENTER to execute the
command.
ESC Key
ESC key function is to leave current menu and return to the last menu. It is also functioned as a
return key or cancel key in the sub-menu.
Press menu to return to main menu.
Menu content:
1. Parameter setup
2. Copy Parameter
3. Keypad Locked
4. PLC Function
5. Copy PLC
6. Fault Record
7. Quick start
8. Display Setup
9. Time Setup
10. Language Setup
11. Startup Menu
12. Main Page
13. PC Link
14. Parameter Settings by Applications
15. History of Parameter Settings
Direction: Left / Right / Up / Down
1. In the numeric value setting mode, it is used to move the cursor and change the numeric
value.
2. In the menu/text selection mode, it is used for item selection.
Function Key
1. The functions keys have factory settings and can be defined by users. The factory settings
of F1 and F4 work with the function list below. For example, F1 is JOG function, F4 is a
speed setting key for adding/deleting user defined parameters.
To Next Page
Loading...
