Delta VFD007FP4EA-41 - Specifications of Control Terminal

Chapter 6 Control Terminals|CFP2000 Series
6-3
6-2 Specifications of Control Terminal
Wire Gauge: 26~16AWG (0.1281-1.318mm
2
);
Torque: Ⓐ 5kg-cm [4.3Ib-in.] (0.49 Nm) (As shown in figure above)
Ⓑ 8kg-cm [6.94 Ib-in.] (0.78 Nm) (As shown in figure above)
Ⓒ 2kg-cm [1.73 lb-in.] (0.19 Nm) (As shown in figure above)
Wiring precautions:
 Reserves 5mm and properly install the wire into the terminal; fasten the installation by a
slotted screwdriver. If the wire is stripped, sort the wire before install into the terminal.
 Flathead screwdriver: blade width 3.5mm, tip thickness 0.6mm
 In the figure above, the factory setting for STO1, STO2, +24V and SCM1, SCM2, DCM are
short circuit. The factory setting for +24V-COM is short circuit and SINK mode (NPN); please
refer to Chapter 4 Wiring for more detail.
Terminals Terminal Function Factory Setting (NPN mode)
+24V
Digital control signal common
(Source)
+24V±5% 200mA
COM Digital control signal common (Sink) Common for multi-function input terminals
FWD Forward-Stop command
FWD-DCM:
ONÎ forward running
OFFÎ deceleration to stop
REV Reverse-Stop command
REV-DCM:
ONÎ reverse running
OFFÎ deceleration to stop
MI1
~
MI8
Multi-function input 1~8
Refer to parameters 02-01~02-08 to program the
multi-function inputs MI1~MI8.
Source mode
ON: the activation current is 3.3
≧mA 11Vdc
OFF: cut-off voltage
≦
5Vdc
Sink Mode
ON: the activation current is 3.3mA
≦
13Vdc
OFF: cut-off voltage
≧
19Vdc
MCM Multi-function Output Common Max 48Vdc 50mA
RA1
Multi-function relay output 1 (N.O.) a
Resistive Load:
3A(N.O.)/3A(N.C.) 250VAC
5A(N.O.)/3A(N.C.) 30VDC
Inductive Load (COS 0.4):
1.2A(N.O.)/1.2A(N.C.) 250VAC
It is used to output each monitor signal, such as drive is in
RB1
Multi-function relay output 1 (N.C.) b
RC1
Multi-function relay common
RA2
Multi-function relay output 2 (N.O.) a
RB2
Multi-function relay output 2 (N.C.) b