Delta VFD9A0MS43ANSHA User Manual

Chapter 12 Description of Parameter SettingsMS300 (High Speed Model)
12-14-3
54: Communication error (CE1)
55: Communication error (CE2)
56: Communication error (CE3)
57: Communication error (CE4)
58: Communication time-out (CE10)
61: Y-connection /
△
-connection switch error (ydc)
62: Decel. energy backup error (dEb)
72: Channel 1 (S1~DCM) safety loop error (STL1)
76: Safe torque off (STo)
77: Channel 2 (S2~DCM) safety loop error (STL2)
78: Internal loop error (STL3)
79: U phase over current before run (Aoc)
80: V phase over current before run (boc)
81: W phase over current before run (coc)
82: U phase output phase loss (oPL1)
83: V phase output phase loss (oPL2)
84: W phase output phase loss (oPL3)
87: Drive over load in low frequency (oL3)
101: CANopen software disconnect 1 (CGdE)
102: CANopen software disconnect 2 (CHbE)
104: CANopen hardware disconnect (CbFE)
105: CANopen index setting error (CIdE)
106: CANopen station number setting error (CAdE)
107: CANopen memory error (CFrE)
121: Internal communication error (CP20)
123: Internal communication error (CP22)
124: Internal communication error (CP30)
126: Internal communication error (CP32)
127: Software version error (CP33)
128: Over-torque 3 (ot3)
129: Over-torque 4 (ot4)
134: Electronics thermal relay 3 protection (EoL3)
135: Electronics thermal relay 4 protection (EoL4)
140: GFF detected when power on (Hd6)
141: GFF occurs before run (b4GFF)
145: Model identification error (MErr)
 As long as the fault is forced to stop, it will be recorded.
 Low voltage (Lv) when stopped (LvS warning, no record). Low voltage (Lv) when operation (LvA,
Lvd, Lvn error, it will be recorded).
 When dEb function is effective and enable, drive will start the dEb function and also record the
error code 62 to Pr. 06-17~06-22, Pr. 14-70~14-73 at same time.

Delta VFD9A0MS43ANSHA Specifications

General

Brand	Delta
Model	VFD9A0MS43ANSHA
Category	Controller
Language	English