Original
1 page(s) Page 1
Declaration for fitting partly completed
machinery
Ident. no.
199 612 44
in accordance with Machinery Directive 2006/42/EC, Annex IIB
Issue 1209 EN
# = Modifications compared to
previous issue
Normung DCC
Class. no.
715 IS 817
Reproduction in whole or in part only with prior consent of Demag Cranes & Components GmbH, D-58286 Wetter Subject to change. Not liable for errors or omissions.
Hereby we,
Demag Cranes & Components GmbH
Ruhrstraße 28, D-58300 Wetter
declare that the electrically driven hoist unit / hoist unit with trolley for
lifting / lifting and moving loads
Demag DC chain hoist / Demag DC chain hoist with trolley
Type:
Bauformschlüssel
Serial no.:
Fabriknummer
as partly completed machinery is intended to be incorporated into machinery and
that it must not be put into service until the machinery* into which this partly
completed machinery is to be incorporated has been declared in conformity with all
relevant provisions of the
EC Machinery Directive 2006/42/EC.
(* provided this machinery is within the application range)
Basic requirements of the EC Machinery Directive insofar as relevant for the scope of
delivery are met by application of the following harmonised standards or C standard
drafts:
EN 14492-2 Cranes - Power-driven winches and hoists - Part 2:
Power-driven hoists
EN 60204-32 Safety of Machinery – Electrical equipment for
machinery, Part 32: Requirements for hoists
The safety objectives of the Low Voltage Directive 2006/95/EC are achieved.
The product additionally complies with the following relevant directives/provisions:
2004/108/EC EC EMC Directive
The relevant technical documentation according to Annex VII Part B of Directive
2006/42/EC has been compiled and shall be made available to authorised national
authorities by the designated authorised representative in response to a justified
request.
Authorised representative for technical documentation
Hans-Jörg Böttcher, Demag Cranes & Components GmbH
Ruhrstraße 28, D-58300 Wetter
Wetter, 29.12.09
ppa. Dr. Harkort ppa. Schulte
Wetter Factory Manager HT/AT Engineering/Development
To Next Page
Loading...
Need help?
General
