Denon AVC-3000 - Last Functionn Meemoty

:
I
cg
a
ep
cp
RES
AVC-3000/3000G
Emm
Amplifier does not operate Batteries dead.
properly when remote control | e Remote contro! unit too far from
unit is used. (When LEARNED/ amplifier.
TX LED is lit) e Obstacle between amplifier and re-
mote control unit.
Learning process to the key improper.
Different key is being pressed.
e Replace with new batteries.
Move closer.
Remove obstacle.
Set learning again.
Press the proper key.
Amplifier does not operate
properly when remote control
unit is used. (When LEARNED/
TX LED is not lit) c
Learning process to the key improper.
e Learning process has not been applied
to the key.
e Batteries dead.
e@ 4 and © ends of battery inserted in
reverse.
e Improper position of PROGRAM
switch.
Set learning again.
Apply learning process.
Remote contro! unit
e Replace with new batteries.
Insert batteries properly.
e Set to desired position (AMP, AUDIO,
or VIDEO).
“PROTECTION” display
appears on superimposed dis-
play and LCD.
Improper speaker cord connection. Connect speaker cord properly.
[11] LAST FUNCTION MEMORY
@ This amplifier is equipped with a last function memory which stores the input and output setting conditions
as they were immediately before the power is switched off.
This
function
eliminates
the
need
to
perform
complicated
resettings
when
the
power
is
switched
on.
e This amplifier is also equipped with a back-up memory. This function provides approximately one day of
memory storage with the power cord disconnected.
Manufactured
under
license
from
Dolby
Laboratories
Licensing
Corporation.
Additionally
licensed
under
one
or
more
of
the
following
patents:
U.S.
numbers
3,632,886,
3,746,792
and
3,959,590;
Canadian
numbers
1,004,603
and
1,037,877.
“Dolby”
and
the
double-D
symbol
o0
are
trademarks
of
Dolby
Laboratories
Licensing
Corporation.
39