Denon AVC-A1XVA - Page 70

70
Select the “HDMI” or “DVI” monitor output
terminal to be used.
This setting can be switched directly using the
MONITOR SELECT button on the Main unit.
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
(Main unit)
Monitor : HDMI
*HDMI/DVI In
4
7
Enter the setting.
The Video Setup menu reappears.
(Main unit) (Remote control unit)
Select the method for playing the audio signals
included in the HDMI input signal.
Select “TV” or “AMP”.
AMP : The audio signals are played according
to the AVC-A1XVA’s speaker systems.
TV : The audio signals are played according
to the number of playable channels on
the monitor connected to the AVC-
A1XVA’s HDMI monitor output terminal.
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
5
Audio : AMP
*HDMI/DVI In
Select the input for the playback of signals when
the audio signal of HDMI can not be reproduced.
When the audio signal of HDMI has become
unlocked, the unit automatically changes over to
the set connector (ANALOG or EXT. IN).
1~5 correspond to each HDMI 1~5 input terminal.
Select input signal (ANALOG or EXT. IN).
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
6
1: EXT-1
*HDMI/DVI In
NOTE:
• If a monitor is connected with an HDMI cable
but the monitor is not compatible with HDMI
audio signal playback, only the video signals
are output to the monitor from the AVC-
A1XVA (DVI mode).
Use the STATUS button to check which
mode is set for outputting HDMI signals from
the AVC-A1XVA (HDMI and DVI modes).