Denon AVC-A1XVA - Procedure for Copying the Flat Correction Curve

83
2 Procedure for copying the “Flat” correction curve set at “Auto Setup”, then using the graphic equalizer to adjust
manually
NOTE: If the “Auto Setup” procedure has not been performed, this item is not displayed.
1
Select “Base Curve Copy”.
BaseCurve Copy
*Manual EQ
(Main unit) (Remote control unit)
2
The Base Curve Select screen appears when the
cursor left button is pressed.
Copy?: No
*Base Curve
(Main unit) (Remote control unit)
3
Select “Base Curve Copy?”, then press the cursor
left button to select “Yes”.
Copy?: Yes
*Base Curve
4
Enter the setting.
The Manual EQ screen reappears.
The type of the copied correction curve is displayed
in the upper right of this screen.
(Main unit)
(Remote control unit)
(Main unit)
(Remote control unit)
(Main unit) (Remote control unit)