Denon AVC-A1XVA - Setting the Type of Speakers for ZONE2

85
3
Set whether speakers are connected or not in ZONE2 and their size parameters.
Select the speakers connected in ZONE2 and the size parameters.
q Select the speaker.
w Select the parameter.
For a description of the different parameters,
see page 50.
ZONE2 Center Sp.
ZONE2 Front Sp.
ZONE2 Subwoofer
ZONE2 Surround Sp.
(ZONE2 Surround back Sp.)
*
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
Front : Small
*Z2 Sp Config.
4
Enter the setting.
The Zone Setup menu reappears.
(Main unit) (Remote control unit)
*
This is only displayed when “7.1ch” is
selected for the ZONE2 channel output
setting at “7-1. Channel Setup”. (See
pages 96 ~ 99)
6-1. Setting the type of speakers for ZONE2
• The composition of the signals output to each channels and the frequency response are adjusted automatically according to the combination of
speakers actually being used in ZONE2.
1
Select “Speaker Config.” at the Zone Setup menu.
2
Display the Speaker Config. screen as below.
Z2 Sp Config.
*Zone Setup
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)