Denon AVR-1000 User Manual

[6] PLAYBACK
@ Preparations for Playback
Check the connections
@ Check that aif connections are proper, referring to the
connections diagrams (pages 8 to 10).
1. Set the MASTER VOLUME control to the
minimum.
(O
Main unit
. Press the POWER button to turn the
power on.
The muting mode is set for several
seconds, after which the STANDBY LED
@ flashes for several seconds.
owen
On/sTaNoey
Cok,
Main unit Remote control unit
3. Select the source to be played.
Audio function button
Example:
| co
Cay
,
| Remote contro! unit
‘ PHONO, CD or TUN-
| ER can be selected
[=k
Main unit
PHONO
directly.
TUNER
The source switch- ‘
es as shown above
MFD.
[——-- Video function button a ara
| Example:
[=k | GS
Main unit Remote control unit
VDP/DBS VDP/DBS, VCR or V-
U AUX can be selected
ie directly.
V-AUX
The source switch-
es as shown above
MFD.
. Start playback of the program source.
For instructions, refer to the source's
operating instructions.
6. Adjust the volume.
oO | Ss
|
Main unit Remote control unit
Press the(A] button to
increase the volume,
the button to de-
crease it.
Turn the control
clockwise to in-
crease the volume,
counterclockwise
to decrease it.
7. Adjust the left/right balance.
Main unit
Turn the control counterclockwise to reduce the
volume of the right channel, clockwise to reduce
the volume of the left channel.
8. Adjust the tone.
Turn the control clock-
wise to increase the
treble, counterciock-
wise to decrease it.
Turn the control clock-
wise to increase the
bass, _ counterclock-
‘
Main unit | Main unit
,
wise to decrease it. |
NOTE:
The sound may be interrupted if switches are operated during playback. This is
because the muting circuit is activated to prevent switching noise.
@ Simulcast playback (playing different video and audio sources simuttaneously)
1. Follow steps 1 to 3 under “Playing the program source”.
2. Select the desired video program source.
|
cx. | aan
Remote control unit
VOP/DBS
4
VCR
4
V-AUX
The source switches as shown above.
3. Follow steps 4 to 8 under “Playing the program source”.
@ Using the muting function
Use this to turn off the audio output temporarily.
1. Press the MUTING button.
{ C3 | This function can only be set
from the remote control unit.
Remote control unit
The STANDBY LED @ flashes when the muting function
is set.
2. Press the MUTING button again.
The muting function is cancelled.
Cancelling simuicast playback
e Press the VIDEO SELECT
button again.
e Press the video function but-
ton on the main unit or re-
mote control unit.
ee

Denon AVR-1000 Specifications

General

Brand	Denon
Model	AVR-1000
Category	Stereo Receiver
Language	English