Denon AVR-1000 User Manual

RECORDING
@ Recording the program source
{recording the source currently being monitored)
1. Follow steps 1 to 3 under “Playing the program source”.
2. Start recording on the tape or video deck.
For instructions, refer to the component's operating
instructions.
Simultaneous recording
NOTES:
- The audio signals selected with the audio or video
function button are output from the DAT/TAPE REC
OUT jacks.
. The recording source switches if the audio function,
video function, personal memory “1° or “2” or tuner
preset buttons are pressed during recording. Do not
Press these buttons during recording.
The signals of the source selected with the function selector button are output simultaneously to the DAT/TAPE and VCR REC OUT
jacks. If a total of two tape and/or video decks are connected and set to the recording mode, the same source can be recorded
simultaneously on both decks.
In addition, if the TAPE MONITOR (DAT/TAPE) button is pressed, the audio signals from the tape deck are output to the VCR AUDIO
REC OUT jacks.
[8] TAPE MONITOR FUNCTION
@ When playing a DAT or tape deck
Use this function to switch between the DAT or tape deck and
the input (source) selected with the audio or video function
buttons.
1, Follow steps 1 and 2 under “Playing the program
source”.
2. Select the deck to be played.
Main unit Remote control unit
DAT/TAPE
if The source switches as shown at the
source _ left.
3. Follow steps 5 to 8 under “Playing the program source”.
12
@ Monitoring the recording on a three-headed tape deck
The sound actually being recorded can be monitored during
recording when a three-headed tape deck is used.
1. Select the deck to be monitored.
XY
Main unit Remote contro! unit
DAT/TAPE
The source switches as shown at the
left.
SOURCE
. Fotlow steps 1 to 3 under “Playing the program source”.
. Start recording on the tape deck. For instructions, refer
to the component's operating instructions.
. Press the three-headed tape deck's source/tape button
to monitor the recording.
[9] USING HEADPHONES
The sound from the speakers can be tured off using the
OUTPUT button to listen to the sound over the headphones
only, for example at night.
. Press the OUTPUT button.
=
Main unit
“H/P ONLY” appears on the MFD.
. Insert the headphones’ plug into the headphones’ jack.
NOTE:
©
Also
refer
to
the
three-headed
tape
deck’s
aperating
(ngtUg
tions.
Cancelling
Either press the OUTPUT button again or press the POWER
button to turn off the power.

Denon AVR-1000 Specifications

General

Brand	Denon
Model	AVR-1000
Category	Stereo Receiver
Language	English