Denon AVR-1000 User Manual

=> Continued
Audio
Section
Video
Section
#Do not plug in the power cord until all connections have been e Note that binding pin plug cords together with power cords
completed.
or
placing
them
near
a
power
transformer
will
resuit
in
the
Be
sure
to
connect
the
left
and
right
channels
properly
(left
introduction
of
hum
or
other
noise.
veo
LD
player,
CDV
player,
BS
tuner,
etc.
with
left,
right
with
right).
e
If
hum
or
other
noise
is
produced
when
the
ground
wire
is
einsert the plugs securely. Incomplete connections will result connected, disconnect it.
in
the
generation
of
noise.
@
Noise
or
humming
may
be
generated
if
a
connected
component is used independently without turning the
power of the AVR-1000 on. If this happens, turn on the
power of the AVR-1000.
Turntable (MM cartridge)
Gor ee ee a
NOTE:
The receiver cannot be used
with MC cartridges directly. Use
a separate head amplifier or
step-up transformer.
}
ANALOG OUTPUT
ourpurs CD player
L
Se
Ground wire
ye
|
TERMwnaL’s
=
qq
>
et
Monitor
TV
|
!
ape-—|]-—
~<a
AVR-1000
{This receiver)
DAT (for recording and playback)
The AVR-1000 is equipped with VIDEO
AUX jacks on the front panel for
playback of video equipment. This
permits video cam-corders with play-
or back functions as well as other equip-
ment to be connected.
Tape deck Cam corder
INPUTS «OUTPUTS:

Denon AVR-1000 Specifications

General

Brand	Denon
Model	AVR-1000
Category	Stereo Receiver
Language	English