Denon AVR-1000 - Connections; Connecting the Antenna Terminals

[5] CONNECTIONS
@ Always turn off the power of the various components when making connections. Also refer to the operating instructions for the
other components.
e Do not plug in the power cord until ali connections are completed.
[ Connecting the antenna terminals
DIRECTION OF
BROADCASTING STATION
FM OUTDOOR ANTENNA
FM INDOOR ANTENNA
75 ohm
ANTENNA OUTDOOR ANTENNA
8 m or
12 m or longer jonger
COAXIAL
ES
From
Wide-
CABLE
if
band
aeriat
Socket
Distances
are
approximate
{ ANTCNNA INSTALLATION 7
eFM ANTENNA
The supplied T-type indoor FM antenna (300 ohms)
can be used inside wooden houses for receiving local
FM stations and other strong FM signals. Stretch out
the ends of the antenna and mount the antenna on
the wall or cailing where optimum reception is
achieved. FM T-type antennas may not consistently
ensure stable reception, due to environment
changes. In such cases, the FM T-type antenna
should only be used temporarily until an outdoor FM
antenna has been installed.
When connecting an outdoor FM antenna, the use of
75 ohm coaxial cable (3C-2V, 5C-2V) is strongly
recommended. Using a 300-ohm feeder cable will
cause noise and you will not be able to achieve the
high sound quality the built-in tuner is capable of
delivering.
eo AM ANTENNA
Attach the supplied AM foop antenna to the antenna
holder on the back panel.
Connect the leads to the AM and GND terminals.
Also use the AM terminals for connecting an outdoor
AM antenna (when making such a connection do not
detach AM loop antenna},
Adjust the loop antenna to obtain optimum recep-
tion. Where broadcast stations are distant and only
weak signals are received, or where signais are
blocked, it is best to install an outdoor AM antenna.
NOTES
This receiver has a full back-up system. When the
power is tured on, the INPUT SELECTOR buttons
are set to the last mode set before the power was
turned off.
@ When using this receiver in close proximity to video
equipment (TV, VCR, VDP, etc.), noise may be
generated in AM broadcasts. To avoid this, keep the
receiver as far away from other video components as
possible, or detach the AM loop antenna from the
antenna holder and place it where noise is reduced. If
the noise is not reduced, turn off the power of the
video components when listening to AM broadcasts.
Note to CATV system installer:
This reminder is provided to call the CATV system
installer’s attention to Article 820-40 of the NEC which
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shail be
connected to the grounding system of the building, as
close to the point of cable entry as practical.