EasyManuals Logo

Denon AVR-2105 Operating Instructions

Denon AVR-2105
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
After setting up the system
1
Press the SYSTEM SETUP button to finish system set up.
This completes the system setup operations. Once the system is set up, there is no need to make the settings again unless other components
or speakers are connected to or the speaker layout is changed.
Auto Tuner Presets
Use this to automatically search for FM broadcasts and store up to 56 stations at preset channels A1 to 8, B1 to 8, C1 to 8, D1 to 8, E1 to 8, F1
to 8 and G1 to 8.
NOTE:
If an FM station cannot be preset automatically due to poor reception, use the “Manual tuning” operation to tune in the station, then preset it
using the manual “Preset memory” operation.
1
Use the CURSOR button to select “Yes”.
“Search” flashes on the screen and searching begins.
“Completed” appears once searching is completed.
The display automatically switches to screen.
36 PRESET <YES
2
Press the ENTER or (down) button if you want to start the settings over from the beginning.
On-screen display signals
Signals input to the AVR-2105/885
VIDEO signal input jack
(yellow)
E
C
E
C
1
2
3
4
S-video signal input jack
E
E
C
C
Video signal output to VIDEO
MONITOR OUT jack (yellow)
C
C
C
E
Video signal output to Color Difference
(Component) Video MONITOR OUT jack
C
C
C
C
On-screen display signal output
(C: Signal E: No signal) (C: On-screen signals output E: On-screen signals not output)
Video signal output to S-
Video MONITOR OUT jack
C
C
C
C
NOTE:
When a component video signal is input and when the “Video Input Mode” is set to the component fixed mode at Input setup, the on-
screen display is only displayed when the System Setup, Surround Parameters and On Screen buttons are operated.
33
ENGLISH

Other manuals for Denon AVR-2105

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-2105 and is the answer not in the manual?

Denon AVR-2105 Specifications

General IconGeneral
Power Output90 W per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
Number of Channels7.1
Component Video Inputs3
AM/FM TunerYes
Response Bandwidth10 Hz - 100 kHz
Signal-To-Noise Ratio102 dB
THD0.08%
Input Impedance47 kOhm
Input Sensitivity200 mV
Tuner BandsAM/FM
Digital Sound Processor (DSP)Yes
HDMI SwitchingNo
Video Conversion/ScalingNo
Output Impedance / Channel8 ohm
Frequency Response10 Hz - 100 kHz
Total Harmonic Distortion0.08%
Dolby DecodingDolby Digital, Dolby Pro Logic II
DTS DecodingDTS, DTS Neo:6
Digital Audio Inputs2 coaxial, 5 optical
Audio D/A Converter24bit / 192kHz
Tuner Frequency RangeAM: 522 - 1611kHz, FM: 87.5 - 108MHz
Dimensions (W x H x D)434 x 171 x 377 mm
Output Power / Channel90W (8 ohms, 20Hz-20kHz, 0.08% THD)

Related product manuals