EasyManuals Logo

Denon AVR-2105 Operating Instructions

Denon AVR-2105
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
Center Sp. Front Sp.Front Sp.
Subwoofer
Surround Sp.
Listening position
Surround Sp.
Surround back Sp.
2 FRONT LARGE
Setting the type of speakers
Set up in function of your speaker systems. Performing this setup optimizes the system.
The composition of the signals output to the different channels and the frequency response are adjusted automatically according to the
combination of speakers actually being used.
1
Set whether or not speakers are connected and, if so, their size
parameters.
•To select the speaker
•To select the parameter
2
Press the ENTER or (down) button to enter the settings and switch to the SPEAKER DISTANCE
setting.
Parameters
Large...................Select this when using speakers that have sufficient performance for reproducing bass sound below the frequency set for
the Crossover Frequency mode.
Small...................Select this when using speakers that do not have sufficient performance for reproducing bass sound below the frequency set
for the Crossover Frequency mode. When this is set, bass sound with a frequency below the frequency set for the Crossover
Frequency mode is sent to the subwoofer.
None……............Select this when no speakers are installed.
Yes/No….............Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.
2spkrs/1spkr.......Set the number of speakers to be used for the surround back channel.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when “Small” is set for the front, center
and surround speakers.
25
ENGLISH

Other manuals for Denon AVR-2105

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-2105 and is the answer not in the manual?

Denon AVR-2105 Specifications

General IconGeneral
Power Output90 W per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
Number of Channels7.1
Component Video Inputs3
AM/FM TunerYes
Response Bandwidth10 Hz - 100 kHz
Signal-To-Noise Ratio102 dB
THD0.08%
Input Impedance47 kOhm
Input Sensitivity200 mV
Tuner BandsAM/FM
Digital Sound Processor (DSP)Yes
HDMI SwitchingNo
Video Conversion/ScalingNo
Output Impedance / Channel8 ohm
Frequency Response10 Hz - 100 kHz
Total Harmonic Distortion0.08%
Dolby DecodingDolby Digital, Dolby Pro Logic II
DTS DecodingDTS, DTS Neo:6
Digital Audio Inputs2 coaxial, 5 optical
Audio D/A Converter24bit / 192kHz
Tuner Frequency RangeAM: 522 - 1611kHz, FM: 87.5 - 108MHz
Dimensions (W x H x D)434 x 171 x 377 mm
Output Power / Channel90W (8 ohms, 20Hz-20kHz, 0.08% THD)

Related product manuals