EasyManuals Logo

Denon AVR-2105 Operating Instructions

Denon AVR-2105
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
Preset memory
DENON and other makes of components can be operated by setting the preset memory.
This remote control unit can be used to operate components of other manufacturers by registering the
manufacturer of the component as shown on the List of Preset Codes (pages 144~148).
Operation is not possible for some models.
1
2
Set mode switch 1 to “AUDIO” or “VIDEO”.
Set mode switch 2 to the component to be registered.
3
2
1
4
Set the AUDIO side for the CD, Tape deck or CDR/MD
position, to the VIDEO side for the DVD/VDP, DBS/CABLE,
VCR or TV position.
3
Press the ON/SOURCE button and the OFF button at the
same time.
•Indicator flash.
4
5
Referring to the included List of
Preset Codes, use the number
buttons to input the preset code (a 3-
digit number) for the manufacturer of
the component whose signals you
want to store in the memory.
To store the codes of another component in the memory,
repeat steps 1 to 4.
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR.....................................................HITACHI
CD, TAPE..................................................DENON
CDR/MD ...................................................DENON (CDR)
DVD/VDP ..................................................DENON (DVD)
DBS/CABLE..............................................ABC (CABLE)
NOTES:
The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control
unit’s transmitting window while setting the preset memory.
Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed on the
included list of preset codes.
Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and
check.
The preset memory can be set for one component only among the following: CDR/MD, DVD/VDP and DBS/CABLE.
1
2
3
456
789
0
35
ENGLISH

Other manuals for Denon AVR-2105

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-2105 and is the answer not in the manual?

Denon AVR-2105 Specifications

General IconGeneral
Power Output90 W per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
Number of Channels7.1
Component Video Inputs3
AM/FM TunerYes
Response Bandwidth10 Hz - 100 kHz
Signal-To-Noise Ratio102 dB
THD0.08%
Input Impedance47 kOhm
Input Sensitivity200 mV
Tuner BandsAM/FM
Digital Sound Processor (DSP)Yes
HDMI SwitchingNo
Video Conversion/ScalingNo
Output Impedance / Channel8 ohm
Frequency Response10 Hz - 100 kHz
Total Harmonic Distortion0.08%
Dolby DecodingDolby Digital, Dolby Pro Logic II
DTS DecodingDTS, DTS Neo:6
Digital Audio Inputs2 coaxial, 5 optical
Audio D/A Converter24bit / 192kHz
Tuner Frequency RangeAM: 522 - 1611kHz, FM: 87.5 - 108MHz
Dimensions (W x H x D)434 x 171 x 377 mm
Output Power / Channel90W (8 ohms, 20Hz-20kHz, 0.08% THD)

Related product manuals