EasyManuals Logo

Denon AVR-2105 Operating Instructions

Denon AVR-2105
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
1
Turn the SELECT knob to select the surround mode.
(Main unit)
When turned clockwise
2
Press the SURROUND PARAMETER button.
Press and hold in the surround parameter button to select the parameter you want to set.
The parameters which can be set differ for the different surround modes. (Refer to “Surround Modes and Parameters” on page 60.
DIRECT
STEREO DOLBY PRO LOGIC
IIx
5CH/7CH STEREO
MONO MOVIE
JAZZ CLUB
ROCK ARENA
VIDEO GAME
MATRIX
VIRTUAL SURROUND
DTS NEO:6
DIRECT
STEREO DOLBY PRO LOGIC
IIx
5CH/7CH STEREO
MONO MOVIE
JAZZ CLUB
ROCK ARENA
VIDEO GAME
MATRIX
VIRTUAL SURROUND
DTS NEO:6
Operating the surround mode and surround parameters from the main unit‘s panel.
1, 321
When turned counterclockwise
To select the surround mode while adjusting the surround parameters, tone defeat or tone control, press the SURROUND MODE
button then operate the selector.
(Main unit)
(Main unit)
3
Display the parameter you want to adjust, then turn the SELECT knob to set it.
Surround parameters e
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small), “medium”, “med.l” (medium-large) and “large”. “small” recreates a small sound
field, “large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level if the sound seems distorted.
DELAY TIME:
In the matrix mode only, the delay time can be set within the range of 0 to 110 ms.
NOTE:
When making parameter settings, the display will return to the regular condition several seconds after the last button was pressed and
the setting will be completed.
59
ENGLISH

Other manuals for Denon AVR-2105

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-2105 and is the answer not in the manual?

Denon AVR-2105 Specifications

General IconGeneral
Power Output90 W per channel (8 ohms, 20 Hz - 20 kHz, 0.08% THD)
Number of Channels7.1
Component Video Inputs3
AM/FM TunerYes
Response Bandwidth10 Hz - 100 kHz
Signal-To-Noise Ratio102 dB
THD0.08%
Input Impedance47 kOhm
Input Sensitivity200 mV
Tuner BandsAM/FM
Digital Sound Processor (DSP)Yes
HDMI SwitchingNo
Video Conversion/ScalingNo
Output Impedance / Channel8 ohm
Frequency Response10 Hz - 100 kHz
Total Harmonic Distortion0.08%
Dolby DecodingDolby Digital, Dolby Pro Logic II
DTS DecodingDTS, DTS Neo:6
Digital Audio Inputs2 coaxial, 5 optical
Audio D/A Converter24bit / 192kHz
Tuner Frequency RangeAM: 522 - 1611kHz, FM: 87.5 - 108MHz
Dimensions (W x H x D)434 x 171 x 377 mm
Output Power / Channel90W (8 ohms, 20Hz-20kHz, 0.08% THD)

Related product manuals