Denon AVR-2308 User Manual


Getting Started Connections Setup Playback Remote Control Information Troubleshooting
ENGLISH
Multi-zone Operations
Turning the Power On and Off
GOperation on the main unitH
Press <ZONE2 ON/OFF> for the zone to be operated.
When the power turns on, the multi-zone indicator ( ) lights on
the display.
GOperation on the remote control unitH
Set [MODE SELECTOR 1] to “AUDIO” and [MODE SELECTOR 2] to
“ZONE2”.
Press [ZONE2 ON] or [ZONE2 OFF].
Selecting the Input Source
GOperation on the main unitH
Turn <SOURCE SELECT>.
GOperation on the remote control unitH
Set [MODE SELECTOR 1] to “AUDIO” and [MODE SELECTOR 2] to
“ZONE2”.
Press [SOURCE SELECT].
Adjusting the Volume
GOperation on the main unitH
Turn <VOLUME> to adjust.
GOperation on the remote control unitH
Set [MODE SELECTOR 1] to “AUDIO” and [MODE SELECTOR 2] to
“ZONE2”.
Press [VOLUME].
– – – –70dB
~
–40dB
~
+18dB[Variable range]
• The volume can be increased up to the value set at menu “Manual
Setup” – “Zone2 Setup” – “Volume Limit” (vpage 29).
• The ZONE2 volume can be adjusted only when “ZONE2” is selected
at menu “Manual Setup” – “Option Setup” – “Amp Assign” (vpage
30).
<ZONE2 ON/OFF>
SOURCE SELECT
VOLUME
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Turning off the Sound Temporarily
Press [MUTING].
The sound is reduced to the level set at menu “Manual Setup” –
“Zone2 Setup” – “Mute Level” (vpage 29).
To cancel, either adjust the volume or press [MUTING] again.
The setting is canceled when the zone’s power is turned off.
The source selected for ZONE2 is also output from the recording
output connectors.
NOTE
Digital audio signals input from the COAXIAL or OPTICAL connectors
cannot be played in multi-zone.
When using ZONE2, it is possible to turn the power for the MAIN
ZONE only on or off by pressing [MAIN ON] or [MAIN OFF].
[MODE
SELECTOR 1]
[MODE
SELECTOR 2]
SOURCE SELECT
VOLUME
[MUTING]
[ZONE2 OFF] [MAIN ON]
[ZONE2 ON] [MAIN OFF]
SOURCE SELECT
[Front]
[Rear]
Multi-Zone

Denon AVR-2308 Specifications

General

Type	AV Receiver
Number of channels	7.1
Total Harmonic Distortion	0.08 %
Input Sensitivity	200 mV
Signal-to-Noise Ratio	100 dB
Tuner Type	AM/FM
HDMI Inputs	2
HDMI Outputs	1
Component video inputs	3
Component video outputs	1
Dolby Digital	Yes
DTS	Yes
Frequency Response	10 Hz - 100 kHz
Video Outputs	composite video x 1, component video x 1
Digital audio inputs	3 x Optical, 2 x Coaxial
Dimensions	434 x 171 x 414 mm
Speaker Impedance	6-16 Ohm