30
Basic Operation Basic Operation
2 DIRECT mode
Use this mode to achieve good quality 2-channel sound. In this
mode, the audio signals bypass such circuits as the tone circuit
and are transmitted directly, resulting in good quality sound.
Playing audio sources (CDs and DVDs)
2-channel playback modes
• The system setup function cannot be used when the PURE
DIRECT mode is set. To use the system setup function, cancel
the PURE DIRECT mode.
• If the HDMI input terminal is selected, video outputs are
outputted in the PURE DIRECT mode.
• The channel level and surround parameters in the PURE
DIRECT mode are the same as in the DIRECT mode.
PURE DIRECT DIRECT/STEREO
• The AVR-3806 is equipped with three 2-channel playback
modes exclusively for music.
• Select the mode to suit your tastes.
Press the DIRECT/STEREO button to select the
DIRECT mode.
The mode switches as shown below each time the
DIRECT/STEREO button is pressed.
2 PURE DIRECT mode
This mode reproduces the sound with extremely high quality.
When this mode is set, all circuits and processes not required for
the selected input source (FL tube, video circuit and tone control,
as well as digital circuitry and other unnecessary circuits for
analog audio inputs) are automatically turned off so the music
signals can be reproduced with high sound quality.
Press the PURE DIRECT button to select the PURE
DIRECT mode.
2 STEREO mode
Use this mode to adjust the tone and achieve the desired sound.
Press the DIRECT/STEREO button to select the
STEREO mode.
To Next Page
Loading...
Need help?
General
