69
Advanced Setup – Part 1 Advanced Setup – Part 1
3
Press the CURSOR
FF
or
GG
button to select the
speaker to be set.
• The screen switches to the character input screen.
Example: When “L/R CH” is selected.
5
Press the ENTER button to enter the setting.
• The “Manual EQ” screen reappears.
6
Press the CURSOR
DD
or
HH
button to select
“Exit”, then press the ENTER button.
• The “Advanced Playback” menu reappears.
The display changes as follows.
When the surround back speaker setting is set to
“1spkr” at “Speaker Configuration”, this is set to
“SB”.
e Select “All CH”
In this case, speaker selection is not performed.
If a value is already set for the FL channel, the data
stored for the FL channel is displayed.
q Select “L/R CH”
w Select “Each CH”
4
Press the CURSOR
DD
or
HH
button to select the
frequency, then press the CURSOR
FF
or
GG
button to adjust the gain level.
Each frequency can be adjusted the range from –20 dB to
+6 dB in 0.5 dB step.
7
Press the CURSOR
DD
or
HH
button to select
“Exit”, then press the ENTER button.
• The “System Setup Menu” reappears.
• “Base Curve Copy” is displayed after performing the Auto
Setup.
•To restore the settings to their defaults, select “Default Yes
0”, then press the CURSOR
FF
button.
• If the “Auto Setup” procedure has not been performed, this
item is not displayed.
Procedure for copying the “Flat” correction
curve
1
Press the CURSOR
DD
or
HH
button to select “Base
Curve Copy”, then press the CURSOR
FF
button.
2
Press the CURSOR
FF
button to select “Yes”.
The type of the copied correction curve is displayed in the
upper right of this screen.
3
Press the ENTER button to enter the setting.
• The “Manual EQ” screen reappears.
ENGLISH
ENGLISH
To Next Page
Loading...
Need help?
General
