Denon AVR-3806

Option Setup
82
Advanced Setup – Part 2 Advanced Setup – Part 2
PageDefault settingsAdvanced Playback
5. Advanced Playback
1
2
2ch
Direct/Stereo
Auto
Surround
Mode
Turn the audio compression on or off when down-mixing
Dolby Digital signals.
3
Dolby Digital
Setup
The speaker settings can be changed specifically for
playing in the 2-channel direct or stereo mode.
Set the Auto surround mode function.
Basic
OFF
Auto Surround Mode = ON
67
68
68
4
This parameter is for optimizing the Room EQ with which
the audio signals are produced from the speakers.
Manual EQ
Setup
All Channels and Frequency = 0 dB
68, 69
PageDefault settings
6. Option Setup
1
Power Amp
Assign
To suit your preference, a surround back channel’s power
amplifier can be assigned to the front channel for bi-amp
playback, ZONE2 or ZONE3.
70
S. Back
72
2
Trigger Out
Setup
This sets the Trigger Out output for the
different input sources.
If “ZONE = MAIN” is selected, settings can be
made for the individual surround modes.
3
Volume
Control
71, 72
Setup Lock
This sets the volume level of each zone output.
Volume Limit:
This sets the upper limit for the master
volume.
Power On Level:
This sets the volume level upon switching on
the power of each zone.
Mute Level:
This sets the amount of attenuation of the
audio output when each zone is muted.
Volume Level:
This sets whether the output level of ZONE2
is fixed or variable.
70, 71
Vol.Limit = OFF, P. On Lev. = LAST, Mute Lev. = FULL
Vol.Lev. = VAR, Vol.Limit = OFF, P. On Lev. = LAST, Mute Lev. = FULL
Trigger
Out 1
ZONE = MAIN, All Surround Modes = ON
This sets whether or not to lock the system
setup settings so that they cannot be changed.
Setup Lock = OFF
Main
Zone2
4
TUNER PHONO CD
CDR /
TAPE
DVD VDP TV
VCR-2DBS VCR-1 V.AUX
OFF OFF OFF OFF ON ON ON ONON ON ON
Trigger
Out 2
ZONE = 2
TUNER PHONO CD
CDR /
TAPE
DVD VDP TV VCR-2DBS VCR-1 V.AUX
ON ON ON ON ON ON ON ONON ON ON
ENGLISH
ENGLISH