Denon AVR-983 User Manual

53
Dolby Digital mode (only with digital input) and DTS Surround mode (only with digital input)
1
Select the input source.
Playback with a digital input
q Select an input source set to digital (COAXIAL/OPTICAL)
(see page 23).
FUNCTION
(Main unit) (Remote control unit)
w Set the input mode to “AUTO” or “DTS”.
(Main unit) (Remote control unit)
2
Select the Dolby/DTS Surround mode.
When performing this operation from the main unit’s panel,
press the SURROUND MODE button, then turn the SELECT
knob and select Dolby Pro logic II or DTS NEO:6.
3
Play a program source with the , mark.
DIGITAL
• The DTS indicator lights when playing
DTS sources.
(Remote control unit)
Light
Light
SELECT
13
2 4,5 2,631
1
2
1
4
3
5, 6
(Main unit) (Main unit)
SIGNAL
DETECT
• The SIGNAL DETECT LED lights
when playing 6.1-channel surround
sources containing the identification
signal.
Light
When the SIGNAL DETECT LED is lit, we recommend
turning the surround back channel using the SURROUND
BACK button on the remote control unit and main unit
during playback.
To use DTS 96/24 sources with the optimum system, we
recommend turning the surround back channel off.
• The Dolby Digital indicator lights
when playing Dolby Digital sources.
Operate the SURROUND BACK button to switch Surround
Back CH ON/OFF.
SURROUND
BACK CH
OUTPUT
• Lights when the Surround Back CH is
on.
Light
(Main unit) (Remote control unit)

Denon AVR-983 Specifications

General

Brand	Denon
Model	AVR-983
Category	Stereo Receiver
Language	English