56
DSP surround simulation
1
Select the surround mode for the input channel.
• To operate the surround mode and surround parameters from the remote control unit.
The surround mode switches in the following order each time the DSP
SIMULATION button is pressed:
2
Display the surround parameter screen on the monitor.
The screen for the selected surround mode appears.
3
Set the parameters.
4
To end the setting mode, press the surround parameter button again.
(Remote control unit)
(Remote control unit)
(Remote control unit)
(Remote control unit)
NOTES:
• When “Default” is selected and the 0 courser button is pressed, “CINEMA EQ.” and “D.COMP.” are automatically turned off, “ROOM
SIZE” is set to “medium”, “EFFECT LEVEL” to “10”, “DELAY TIME” to “30ms” and “LFE” to “0dB”.
• The “ROOM SIZE” expresses the expansion effect for the different surround modes in terms of the size of the sound field, not the actual
size of the listening room.
To Next Page
Loading...
Need help?
General
