57
• Operating the surround mode and surround parameters from the main unit‘s panel.
1
Turn the SELECT knob to select the surround mode.
• When turned clockwise
• When turned counterclockwise
2
Press the SURROUND PARAMETER button.
Press and hold in the surround parameter button to select the parameter you want to set.
• The parameters which can be set differ for the different surround modes. (Refer to “Surround Modes and Parameters” on page 60.)
3
Display the parameter you want to adjust, then turn the SELECT knob to set it.
(Main unit)
(Main unit)
To select the surround mode while adjusting the surround parameters or tone control, press the surround mode button then operate
the selector.
NOTE:
• When playing PCM digital signals or analog signals in the DOLBY PRO LOGIC II, DTS NEO:6 modes and the input signal switches to a digital
signal encoded in Dolby Digital, the Dolby surround mode switches automatically. When the input signal switches to a DTS signal, the mode
automatically switches to DTS surround.
(Main unit)
DIRECT STEREO DOLBY PRO LOGIC II DTS NEO:6 5/7CH STEREO
DIRECT STEREO DOLBY PRO LOGIC
II DTS NEO:6 5/7CH STEREO
MONO MOVIE
MONO MOVIE
ROCK ARENAJAZZ CLUBVIDEO GAMEMATRIXVIRTUAL
ROCK ARENAJAZZ CLUBVIDEO GAMEMATRIXVIRTUAL
To Next Page
Loading...
Need help?
General
