107
General
Language
Default settings are underlined.
Set the language for display on the menu screen.
Setting details
English / Français / Español
“Language” can also be set by the following procedure. However, the menu screen is not displayed.
Following the display content to make the setting.
1. Press and hold the main unit’s TUNER PRESET CH + and STATUS for at least 3 seconds.
“< NTSC >” appears on the display.
2. Press the main unit’s DIMMER and set “< ENGLISH >”.
3. Use the main unit’s SOURCE SELECT 0 1 and set the language.
4. Press the main unit’s STATUS to complete the setting.
Quick Sel.Names
Change the “Quick Select” display title to one you prefer.
Setting details
Quick Select 1 / Quick Select 2 / Quick Select 3 / Quick Select 4
•Up to 16 characters can be input.
•For character input, see page84.
Set Defaults : The input source name is returned to the default setting.
•Reset : Reset to the defaults.
•Cancel : Do not reset to the defaults.
If you select “Set Defaults” and press ENTER, the message “Reset all
Quick Select names to the factory default?” is displayed. Select “Reset” or
“Cancel”, and then press ENTER.
Auto Standby
Default settings are underlined.
When you do not perform any operation on this unit with no audio or video input for a specified time,
this unit automatically enters the standby mode. Before it enters the standby mode, “Auto Standby” is
displayed on the display of this unit and the menu screen.
Setting details
60 min : The unit goes into standby after 60 minutes.
30 min : The unit goes into standby after 30 minutes.
O : The unit does not go into standby automatically.
Front Display
Default settings are underlined.
Makes settings related to the display on this unit.
Setting items Setting details
Dimmer
Adjust the display
brightness of this unit.
Bright : Normal display brightness.
Dim : Reduced display brightness.
Dark : Very low display brightness.
O : Turns the display o.
Buttons on the main unit can be used for operations.
Each time DIMMER is pressed, the setting is changed as shown
below.
Bright Dim
DarkOff
NOTE
When “Dimmer” is set to “O”, the display turns o and appears as if
there is no electricity.
To Next Page
Loading...
Need help?
General
