Denon AVR-S910W

Sound mode
Surround Parameter
Tone
z7
Audyssey
Restorer
z10
Room Size Center Spread DTS Neural:X
MultEQ® XT
z8
Dynamic EQ
z9
Dynamic Volume
z9
Direct/Pure Direct (2-channel) z5
Direct/Pure Direct (Multi-channel) z5
Stereo
SSSSS
Multi Ch In
SSSS
Dolby Surround
S SSSSS
DTS Neural:X
SSSSS
Dolby Digital
SSSS
Dolby Digital Plus
SSSS
Dolby TrueHD
SSSS
Dolby Atmos
SSSS
DTS Surround
SSSS
DTS 96/24
SSSS
DTS-HD
SSSS
DTS Express
SSSS
DTS:X
SSSSS
Multi Ch Stereo
SSSSS
Rock Arena
S SSSSS
Jazz Club
S SSSSS
Mono Movie
S SSSSS
Video Game
S SSSSS
Matrix
SSSSS
Virtual
SSSSS
z
5,
z
7 -
z
10: “Sound modes and surround parameters” (
v
p. 259)
Contents Connections Playback Settings Tips Appendix
258
Front panel Display Rear panel Remote Index
z
1
This item can be selected when a Dolby Digital, Dolby Digital Plus, Dolby TrueHD or Dolby Atmos signal is played.
z2
This item can be selected when a Dolby TrueHD, Dolby Digital or DTS signal is played.
z3
This item can be selected when a DTS:X signal that is compatible with the Dialog Control function is input.
z4
This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z5
During playback in Pure Direct mode, the surround parameters are the same as in Direct mode.
z6 This setting is available when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v
p. 204)
z7 This item cannot be set when “Dynamic EQ” is set to “On”. (v
p. 161)
z8
This item cannot be set when Audyssey
®
Setup (Speaker Calibration) has not been performed.
z9
This item cannot be set when “MultEQ
®
XT” is set to “Off”. (v p. 161)
z
10
This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
Contents Connections Playback Settings Tips Appendix
259
Front panel Display Rear panel Remote Index
78