Denon AVR-X3000

Error
Code
Details of Error code Display Coping strategies
11
Main CPU failed to receive
rmware for rewriting sent from
DM860A (when an error occurred)
U p d a t i n g f a i l 1 1
Turn off and on the power. Updating starts
automatically.
12
There was invalid data in the
rmware for rewriting sent from
DM860A to Main CPU (when a
Check Sum error occurred).
U p d a t i n g f a i l 1 2
Turn off and on the power. Updating starts
automatically.
13
The deletion of block data failed
before Main CPU was rewritten.
E r a s e f a i l 1 3
Turn off and on the power. Updating starts
automatically.
14
The rewriting of block data failed
when Main CPU was rewritten.
U p d a t i n g f a i l 1 4
Turn off and on the power. Updating starts
automatically.
15
The data verication was invalid
after Main CPU was rewritten.
U p d a t e C h e c k N G 1 5
Turn off and on the power. Updating starts
automatically.
20
Failure to acquire (Boot Loader
Mode) IP address before rewriting
DM860A (AutoIP).
C o n n e c t i o n F a i l 2 0
Check the network connection.
Carry out the update in an environment that
has little network load.
21
Failure to acquire (Boot Loader
Mode) IP address before rewriting
DM860A (when timed out).
C o n n e c t i o n F a i l 2 1
Check the network connection.
Carry out the update in an environment that
has little network load.
22 Log-in to DPMS failed.
L o g i n f a i l e d 2 2
Reset and update again.
Carry out the update in an environment that
has little network load.
23
Line, etc., is busy when logging
into DPMS.
S e r v e r i s b u s y 2 3
Carry out the update in an environment that
has little network load.
24 Connection to DPMS failed.
C o n n e c t i o n F a i l 2 4
Check the network connection.
Carry out the update in an environment that
has little network load.
25 Mode change failure of DM860A.
C o n n e c t i o n F a i l 2 5
Reset and update again.
26
Data acquisition failed (timed out)
when rmware of Main CPU was
downloaded. Received Package
Version is wrong.
D o w n l o a d f a i l 2 6
Check the network connection.
Carry out the update in an environment that
has little network load.
27 Mode change failure of DM860A.
C o n n e c t i o n F a i l 2 7
Reset and update again.
36
Log-in to DPMS ailed when
rmware such as Sub CPU, DSP,
FPGA, and PLD was rewritten.
L o g i n f a i l e d 3 6
Carry out the update in an environment that
has little network load.
37
Line, etc., is busy when logging
into DPMS when rmware such as
Sub CPU, DSP, FPGA, and PLD
was rewritten.
S e r v e r i s b u s y 3 7
Carry out the update in an environment that
has little network load.
38
Connection to DPMS failed when
rmware such as Sub CPU, DSP,
FPGA, and PLD was rewritten..
C o n n e c t i o n F a i l 3 8
Check the network connection.
Carry out the update in an environment that
has little network load.
67