21
D-A03
Detailed Description of Error Indication
Can't REC
DEFECT occured continuously for 10 times during
REC-PLAY
Record enable cluster become 0 due to DEFECT
occurrence during REC-PLAY.
Unable to read address. However repeating try, unable
to enter REC mode in 20 seconds.
Can't COPY
NO SIGNAL
TOC FULL
Can't u READ
TOC FROM a
TOC FROM L0~4
NOT AUDIO
? DISC
DISC FULL
PROTECTED
Can't EDIT
TEMP OVER
Error Indication Content of Error Remedy
Is there any scratch, dust, finger print, black spot, etc. on
the disc? Check for eccentricity, warp, etc. of disc.
With the channel status of input digital signal from D-IN
during REC-PAUSE or RE-PLAY, it is judged as follows.
(1) Except audio.
(2) Except public use.
(3) Copy NG by reverse of CD COPY bit.
Check if the copy inhibit.
(Example: CD-R, etc.)
Becomes as follows against the digital signal input from
D-IN during REC-PAUSE, REC-PLAY or CD FUNC
playback.
(1) Digital IN PLL is UNLOCKED.
(2) Locked other than FS=44.1 kHz
Check for abnormality in D-IN signal line.
No registering area for character information. (music
name, disc name, etc..)
No recording area in UTOC remained when entering
REC-PAUSE.
No remaining program area for music data.
Replace with another disc having record area remained.
FTNO > LTNO.
FTNO ≠ 0 or 1.
Unable to read UTOC recorded on the disc.
Replace with the other disc as abnormality exists in data
of UTOC.
Start address > End address when TOC read. Replace with the other disc as abnormality exists in data
of UTOC.
One of UTOC 0~4 data is looped when TOC read. Replace with the other disc as abnormality exists in data
of UTOC.
Other than audio data is recorded in TNO track mode
with oresently selected music.
Select other TNO or replace with other disc.
Not a MD format disc is inserted. Out of spec disc, replace with others and check.
When entering REC-PAUSE or edit, found that the disc
is for playback only.
As the disc is playback only, replace with a recording
disc.
Attempted to record or edit as the mis-erasure
preventive knob of REC/PLAY disc set to preventive
position.
Attempted to edit the write protect track by information
written in UTOC.
Set the mis-erasure preventive knob back to the former
position and retry.
As the track attempted to edit is write protect, try it in the
other track.
The temperature inside (MD unit) is too high due to
abnormality.
Check according to the troubleshooting.
Avoid using in a high temperature.
Can't r READ ∗
(∗ is the symbol of
number)
As a result of reading data, the data is not correct.
Unable to read correctly.
As abnormality occurred while recording music data,
unable to perform correct recording.
Abnormality in data of TOC, UTOC, disc scratch, etc.
Replace with the other disc.
Can't READ s
Can't READ r
Attempted to read TOC, but couldn’t.
As a result of reading TOC, data is not correct.
TOC information recorded on disc is not met with the MD
spec requirement. Replace with the other disc.
Scratch, etc. on the disc, Replace with the other disc.
At each edit function, editing conditions are not satisfied. Operating method is wroug. Try it again with correct
manner.
To Next Page
Loading...
Need help?
General
