26
2.4. Replace the BD MECHA UNIT ASSY
(1) Remove the MECHA COVER.
(2) Move the optical pickup to the outer circumference, remove the FFC, and remove the screws.
(3) Attach the BD MECHA for replacement to the set unit. (When assembling the unit, perform the steps in reverse
order.)
(4) Check that the 45P-FFC, 9P-FFC and 5P-PH connector cords have been connected.
2.5. Congure the settings of the set that contains the new BD MECHA
(1) Check the laser amperage (see laser on/off mode in the test mode (page 32)).
Check that the values are ±6 [mA] from the initial value for BD, and ±12 [mA] from the initial value for DVD/CD.
(2) Clear the total laser usage time (see the procedure for clearing the accumulated laser on time in test mode (page
33)).
(3) Check BD, DVD, and CD media playback.
(4) If there are no problems with playback, remove the disc, press the ON/STANDBY button to switch to standby status,
and remove the AC plug from the AC socket.
(5) Attach the top cover, and this completes the replacement procedure.
MECHA COVER
J1 45P-FFC
XP8 9P-FFC
5P-PH CORD
To Next Page
Loading...
