36
PROCEDURE FIRMWARE FOR UPGRADING THE VERSION OF THE
FIRMWARE
You can update by downloading the latest version from the Internet.
1. Update from the Internet
1.1. preparation
(1) System requirements
• Internet Connection by Broadband Circuit
• Modem
• Router
• Ethernet cable (CAT-5 or greater recommended)
(2) Setting
1.2. Checking and updating the rmware
Check if the latest rmware exists. You can also check approximately time required to complete an update.
(1) Press the SETUP button on the remote control to display the GUI menu.
(2) Use the cursor buttons to select "General Setting" → "System" → "Firmware Update" → "Update check".
(3) Press the ENTER button.
• If the rmware on the website is latest, proceed to (4) Press Enter Button.
• If the latest rmware has been already installed, press the RETURN button to return to SETUP menu.
(4) Press the ENTER button.
• When updating is completed, return to normal status about 20 seconds later.
--- Cautions on Firmware Update ---
• In order to update the rmware, you must have the correct system requirements and settings for a broadband Internet
connection.
• Do not turn off the power until updating is completed.
• Once updating starts, normal operations on this unit cannot be performed until updating is completed. Also, setting
items of the GUI menu of this unit or setting items of the image adjustment may be initialized.
Note down of the settings before updating, and set them again after updating.
NET WORK
connector
Modem
Internet
Computer
LAN port/Ethernet connector
Router
To WAN port
To LAN port
To LAN port
To Next Page
Loading...
