28
1.6. Operation check
(1) Connect the 45P FFC of J1.
(2) Attach the MECHA COVER.
(3) Attach the TOP COVER.
(4) Follow the rmware update procedure, and update the rmware to the latest version.
(see "VERSION UPGRADE PROCEDURE OF FIRMWARE")
(5) Check the laser amperage (see laser on/off mode in the test mode (page 32)).
Check that the values are ±6 [mA] from the initial value for BD, and ±12 [mA] from the initial value for DVD/CD.
(6) Check BD, DVD, and CD media playback and operation.
(7) If there are no problems with playback, remove the disc, press the ON/STANDBY button to switch to standby
status,and remove the AC plug from the AC socket.
(8) Completes the replacement procedure.
Note: In the case of exchange, only MAIN PCB UNIT is cleared in the laser total use time.
J1 45P FFC
To Next Page
Loading...
