21
Explanation terms
B
Bit rate
This expresses the read amount per 1 second of
video/audio data recorded in a disc.
F
Finalize
This is processing that enables playing back of disc
of CD, which was recorded using a recorder, by
other players.
M
MP3 (MPEG Audio Layer-3)
This is an internationally standardized audio data
compression scheme, using the “MPEG-1” video
compression standard. It compresses the data
volume to about one eleventh its original size while
maintaining sound quality equivalent to a music CD.
S
Sampling frequency
Sampling involves taking a reading of a sound wave
(analog signal) at regular intervals and expressing
the height of the wave at each reading in digitized
format (producing a digital signal).
The number of readings taken in one second is
called the “sampling frequency”. The larger the
value, the closer the reproduced sound is to the
original.
W
WMA (Windows Media Audio)
This is audio compression technology developed by
Microsoft Corporation.
WMA data can be encoded using Windows Media
®
Player Ver.7, 7.1, Windows Media
®
Player
for Windows
®
XP and Windows Media
®
Player 9
Series.
To encode WMA files, only use applications
authorized by Microsoft Corporation. If you use
an unauthorized application, the file may not work
properly.
Troubleshooting
If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
GGeneralH
Symptom Cause Countermeasure Page
When the power
is turned on, the
power indicator
does not light
and no sound is
produced.
•Connection of the power cord is
faulty.
•Check that the power plugs are
securely inserted into the wall
power outlet.
6
The power
indicator lights
but no sound is
produced.
•The amplifier is not set to the
proper function (input).
•The volume is set too low.
•Switch to the correct function
(input).
•Adjust the volume to an
appropriate level.
–
–
Power
automatically
switches to
standby mode.
•Auto standby function is set to
ON.
•To disable the auto standby
function.
16
GRemote Control UnitH
Symptom Cause Countermeasure Page
Set does not work
properly when
remote control
unit operated.
•The system cable between the
DCD-F109 and DRA-F109 is not
properly connected.
•Batteries are worn.
•You are operating outside of the
specified range.
•Obstacle between main unit and
remote control unit.
•The batteries are not inserted in
the proper direction, as indicated
by the polarity marks in the
battery compartment.
•The set’s remote control sensor
is exposed to strong light
(direct sunlight, inverter type
fluorescent bulb light, etc.).
•Connect securely.
•Replace with new batteries.
•Operate the remote control unit
within a distance of about 7
meters and an angle of 30° from
the DRA-F109.
•Remove the obstacle.
•Insert the batteries in the
proper direction, following the
polarity marks in the battery
compartment.
•Move the set to a place in which
the remote control sensor will
not be exposed to strong light.
17
–
–
–
–
–
To Next Page
Loading...
