Denon DN-V310 - Description of PS Commands; Get Player Status Command (GetStatus)

１３
4 Description of PS Commands
Ⅱ. External Control Status: PS group
Detailed description of the status confirmation commands
11. Get player status confirmation request ( GetStatus ) ---- Valid when the power is on
<Format> [PS,GetStatus]<CR>
<Reply> [PS,GetStatus,Error code,Status code]
(For the error codes, refer to the list of error codes on page 6.)
<Details> ・Sends a request for the DN-V310’s operating status.
・In response to the request, the DN-V310 returns the error code corresponding to the
sent command and the status code indicating the DN-V310’s status.
・
During loading, the DN-V310 does not respond to the command, and the received command is
not valid. Send the command again after loading is completed or until there is a response.
List of status codes
Code
Name Description
0 Error Disc error or other problem has arisen
1 Opened Tray is open
2 No Disc Tray is closed by no disc is loaded
3 Stopped Stop mode condition
4 Playing Play mode condition
5 Pause Still or pause mode condition
Example: To get the DN-V310’s operating status
[PS,GetStatus]<CR> →
A request for the DN-V310’s operating status is sent from the controller.
[PS,GetStatus,0,4] ← The sent message’s error code 0 (no error) and status code 4
(Playing) are returned from the DN-V310.