Denon DN-V310 - Appendix 3 Stopping and Resuming Status of DVD

２４
Appendix 3 Stopping and Resuming Status of DVD
With the DN-V310, when playing a DVD, when the stop operation is performed or the stop command is
issued for the first time, the DN-V310 changes to the resume mode, and when the stop operation is
performed or the stop command is issued for a second time, the DN-V310 changes to the stop mode.
The response to serial remote commands according to the device’s status is defined as shown below.
The validity of commands depends on the device’s status, so be careful when controlling by serial
remote.
The DN-V310 is designed to issue the “PR StatusChange” message when a change of status occurs,
but the resume and stop modes are not distinguished, and both have the status code “3”.
To switch to the stop mode by serial control when playing a DVD, issue the “STOP” command two times
by PC RC command.
Example: To switch to the stop mode while playing a DVD
[PC,RC,49]<CR> → First stop message sent from the controller.
[PC,RC,0] ←
The sent message’s error code 0 (no error) is returned from the DN-V310.
[PR,StatusChange,3] ←
The DN-V310 switches to the resume mode and a message is issued.
[PC,RC,49]<CR> → Second stop message sent from the controller.
[PC,RC,0] ←
The sent message’s error code 0 (no error) is returned from the DN-V310.
The DN-V310 switches to the stop mode. (No message is issued.)
group
groupgroup
group command
commandcommand
command DVD STOP
DVD STOPDVD STOP
DVD STOP DVD RESUME
DVD RESUMEDVD RESUME
DVD RESUME
RC
RCRC
RC
PlayT
PlayTPlayT
PlayT
・OK→Title Play
・NG→Error code2
Error code10
PlayC
PlayCPlayC
PlayC
・OK
→Title&Chapter
PLAY
・ChapNG→Error code2
・TitleNG→Error code2
Error code10
Time
TimeTime
Time
・OK→Time Play
・NG→Error code2
Error code10
SetAST
SetASTSetAST
SetAST Error code10 Error code10
SetSPST
SetSPSTSetSPST
SetSPST Error code10 Error code10
GetStatus
GetStatusGetStatus
GetStatus Status ：3 Status3
GetDiscType
GetDiscTypeGetDiscType
GetDiscType Code：1 Code：1
GetAST
GetASTGetAST
GetAST Error code1 Memorized No.
GetSPST
GetSPSTGetSPST
GetSPST Error code1 Memorized No.
GetT
GetTGetT
GetT Error code1 Memorized No.
GetC
GetCGetC
GetC Error code1 Memorized No.
PC control
PC controlPC control
PC control
V310 response
V310 responseV310 response
V310 response
PS
PSPS
PS
Same as IR remote controler
PC
PCPC
PC