Denon DRA-275RD - Disassembly Procedures

ENGLISH
SPEAKER CONNECTION
Confirm polarity (+, —) and left and right channels (L, R). Connect the speaker
pairs to the SPEAKER terminals A or B on the back panel. Connections must be
made with power cord disconnected.
Preparing the cord
1. Peel off the sheath.
2. Twist the wires.
Connecting the front speaker terminals
1. Loosen by turning counterclockwise.
2)
2. Insert the cord and tighten by turning clockwise.
° af
e@ Speaker Impedance
@ When speaker systems A and B are use separately, speakers with an im-
pedance of from 6 to 16 Q/ohms can be connected.
® Becareful when using two pairs of speakers (A + B) at the same time,
since use of speakers with an impedance outside the range of 12 to 16
Q/ohms will lead to damage.
@ The protection circuit may operate or damage may occur when speakers
with an impedance outside of the above range are used.
10
ANTENNA INSTALLATION
e FM ANTENNA
The supplied indoor FM antenna can be used inside wooden houses for re-
ceiving local FM stations and other strong FM signals. Stretch out the ends
of the antenna and mount the antenna on the wall or ceiling where optimum
reception is achieved. A indoor FM antennas may not consistently ensure
stable reception, due to environment changes. In such cases, the indoor FM
antenna should only be used temporarily until an outdoor FM antenna has
been installed.
When connecting an outdoor FM antenna, the use of 75 Q/ohms coaxial
cable (8C-2V, 5C-2V) is strongly recommended.
Note:
@ Donot connect two FM antennas simultaneously.
e AMLOOP ANTENNA
Tune in an AM station, listen to the sound, then install the antenna ina position
as far from the set as possible in which distortion and noise are minimum.
Good reception of AM stations is not possible if the loop antenna is not con-
nected or if it is touching metal objects.