Denon DRA-275RD - Adjustment Methods; Idling Current Adjustment

ENGLISH
8. EON-TA
When an RDS station is broadcasting RDS information on other stations with-
in the same network and a traffic announcement begins on another station in
the same network based on this information (EON = Enhanced Other Net-
work), that network station is automatically tuned in. The previous station is
tuned back in once the traffic announcement is over.
Operation
1. Press the EON-TA button © .
(The EON TA indicator lights,)
(STATION A )
(When a traffic announcement starts, that station is automatically tuned
in.)
(STATION B )
(When the traffic announcementis over, the previous station is tuned back
in.)
(STATION A )
NOTE:
Be sure to turn the EON-TA mode off when recording programmes.
=
2. $n the EON-TA mode, if the station is switched from the current station to
another station in the network but the signals of that network station are weak
and it cannot be tuned in properly, “WEAK SIGNAL” is displayed and the origi-
nal station is immediately tuned back in.
* The following programme types (PTY) can be designated:
NEWS NEWS
AEF FRIRS AFFAIRS
INFORMATION INFORMATION
erga Mises SPORT OT
EDUCATION EDUCATION
URAMA DRAMA
CU LEE RE CULTURE
SCIENCE
VARIED VARIED
POP Mis TC POP MUSIC
Pek Geis Sl ie ROCK MUSIC
Table of characters
ER MUSIC
3. Inthe EON-TA mode, the station does not switch to another station in the net-
work if the current station is broadcasting a traffic announcement.
4. Since the RDS services offered differ from station to station, some RDS func-
tions may not operate for some stations, but this is not a malfunction.
9. Writing station names
You can write in station names yourself.
{Up to 8 characters)
(Refer to the table of characters on page 12.)
Operation
1. Press the RDS button 4 times.
2. Use the TUNER UP and
DOWN buttons @ to select
the desired characters.
3. Use the SHIFT/PTY button@
to move to the next place.
4, After writing the entire station
name, store it in the memory.
(refer to page 7.)
Display
First space flashes.
First letter flashes.
Specified place flashes.
Each operation should be completed while the specified place is flashing.
NOTE: This unit may not identify RDS stations as such if the paging station pro-
vides multiple RDS data. Tuning may not stop at such stations during the
RDS search and PTY search operations.
RDS Emergency Alarm
“ALARM" will flash on the display when the unit receives the Emergency Pro-
gramme Type Code (PTY31) from an RDS station.
This feature may not operate properly if the signal from the RDS station is too
weak or is subjected to interference.
It is not possible to select the "ALARM" display from the PTY search mode.
10. Clearing station names
1. Recall the station name you want to clear.
2. Press the RDS button 4 times until the character at the first place flashes.
3. Then press the SHIFT/PTY button for at least 2 seconds. The current sta-
tion name will then be cleared.
Note: Station names must be stored in a preset memory to be retained. If the
power is turned off, or if the band (AM/FM) is changed, the station
name will be lost. Be sure to store the entered station name ina Preset
Memory before changing the band or turning the power switch OFF.
M.O.R. MUSIC
LIGHT CLASSICS
SERIOUS CLASSICS
OTHER MUSIC
The characters are input in the order shown to the right. Use the TUNER UP/DOWN buttons ® to select the desired characters.
H
N
ASL DER GAL oR LOM
MNOPQRST
01234567850 \ 3-8’
tiviow
Sipe ies SE
12
Priv ad.
Kae