ENGLISH
Connections
DD
DD
Connections
I Subwoofer I
Connection terminal for
[J
subwoofer with built-in
~
amplifier.
.00'
e:
~IN
oConnections
• When making connections, also refer to the operating instructions of the other components.
Note
on
speaker impedance
When using speakers
with
an
impedance
below the designated value (for example 4
Q/ohms), playing for long periods of time with
the volume high could cause the temperature
to rise, activating the protection circuit.
When the protection circuit
is
activated, the
output
to
the speakers
is
cut
off
and
the power
indicator blinks. If this happens, unplug the
power cord, wait for the set to cool off and
improve ventilation around the unit. Also check
the wiring of the input cables
and
the speaker
cables. After doing this, plug the power cord
back
in
and
turn the unit's power back
on.
If the protection circuit
is
activated again even
though there are no problems with the wiring or
the ventilation around the unit, switch off the
power and contact a DENON service center.
~
1.
Loosen by turning
S~
counterclockwise.
'
Either tightly
twist
or terminate the core
~
wires.
2.
Insert the cable.
{}
Jl
~
3.
Tighten
by
turning clockwise.
Speaker connections
NOTE:
When making connections, take care
that
none
of
the individual conductors of the
speaker cable come
in
contact with adjacent
terminals,
with
other speaker cable
conductors, . or
with
~he
rear panel and
screws.
NEVER touch the speaker terminals when
the power
is
on. Doing
so
could result
in
electric shocks.
Connect the speaker terminals with the speakers 0 Speaker impedance
making sure that like polarities are matched
(€f)
with
€f),
8·with
8).
Turn
clockwise to tighten, then
~
insert the banana plug.
:b~~
~,~
~~~
Speakers
(8)
Speakers
(A)
7
ENGLISH
To Next Page
Loading...
