Operation
Use
this procedure to view photo
and
video data stored
on
the
iPod
on
a monitor.
•
To
output photo or video
data
recorded
on
the
iPod
to the monitor,
the iPod's
"TV Out" setting (under "Video Settings") must be set to
"ON".
For
details, refer to the iPod's operating instructions.
* The iPod
can
be disconnected after switching
toafunction
other
than the one to
which
the iPod input is assigned.
Recording
the
program source (recording the
source currently being monitored)
• The AUDIO IN's signal selected with
INPUT
SELECTOR
are output to
the CD-RffAPE
and
VCR
AUDIO OUT terminals.
oSimultaneous recording
The signals of the source selected with
INPUT
SELECTOR
are output
simultaneously to the CD-RffAPE
and
VCR
REC
OUT terminals. If a
total
of
two
tape and/or video decks are connected
and
set to the
recording mode, the same source
can
be
recorded simultaneously
on
every decks.
18
ENGLISH
ENGLISH
Operation
About
the
memory
functions
oLast function
memory
The various settings set when the DRA-297's power
is
switched to
standby
are
stored
in
the memory. When the power
is
turned back
on,
the settings made when the power was switched to standby
are
recalled.
oBackup
memory
The
various settings are stored
in
the memory for about 1 week, even
when the power
is
turned
off
or the power cord
is
unplugged.
Initialization of
the
microprocessor
If the indication
on
the display
is
not normal or if the operation of the
unit
is
not correct, then the microprocessor should
be
reset by the
following procedure.
1.
Switm
off
the
lIDitusiog<POWEB>.
3Check
that
the entire
eli
ay is ftasbiDg
at
l-second
intervals
and
release the buttons.
• The microprocessor will be initialized.
• If step 3 does not work, start over from step 1.
• If the microprocessor
has
been reset,
all
the button settings are
reset to the default values (the values set upon shipment from the
factory).
To Next Page
Loading...
