Denon DRA-500AE - Operation; Before Operating; Playing the Input Source; Turning the Sound off Temporarily (MUTING)

ENGLISH
ENGLISH
11
Operation
Playing the input source
Use INPUT SELECTOR to select the input source you
want to play.
Use VOLUME to adjust the volume.
• The volume level is displayed on the volume level display.
1
3
Start playback on the selected component.
For operating instructions, refer to the component’s manual.
2
About the button names in this explanation
<>
: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
[POWER ON]
INPUT SELECTOR
VOLUME
[MUTING]
STATUS
PRESET
<POWER>
INPUT SELECTOR
<SPEAKER>
<PURE DIRECT>
VOLUME
<ON/STANDBY> <PHONES>
STATUSPRESET
<DIMMER>
<TONE CONTROL>
<SELECT>
<CH VOL>
<TONE DEFEAT>
<LOUDNESS>
Before operating Turning the sound off temporarily (MUTING)
Press [MUTING].
• Canceling MUTING mode:
To cancel the muting mode, either press
[MUTING] or adjust the
volume.
Connect the headphones to
<
PHONES
>
.
• No sound is produced from the speakers automatically.
NOTE:
•To prevent hearing loss, be careful not to raise the volume level
excessively when using headphones.
Listening over headphones
Switching the speakers
Press
<
SPEAKER
>
to turn the corresponding speaker pair
on.
Press
<
ON/STANDBY
>
or [POWER ON].
• The power indicator blinks green and the power turns on.
Press
<
POWER
>
.
£ OFF:
The power turns off and the indicator is off.
¢ ON:
The power indicator lights red.
1
2